When you need to extend Ethernet services beyond the IEEE 802.3 limits of 100m / 328ft, and new fibre cabling is too expensive, the Perle eR-S1110 Ethernet Repeater is the perfect solution. Transparently extend 10/100/1000 Ethernet connections across twisted pair ( CAT5/6/7 ) to extend your network distance an additional 100m (328ft).
This simple and effective point to point Ethernet Repeater and Rate Converter is perfect for commercial buildings, residential units, hospitality environments or for connecting a remote office or private-network backbone to a corporate LAN. Use it anywhere you need Ethernet communication links between separated LANs or LAN devices (i.e. PCs, digital sensors, VoIP phones, WiFi APs, IP cameras and more).
The eR-S1110 Repeater can also operate as a Powered Device (PD) under IEEE 802.3af supporting end-span and mid-span power sources (PSE). This makes it ideal for organizations that need to deploy equipment in locations that are difficult or too costly to have separate AC power installed such as ceilings, walls and kiosks.
Perle’s advanced features such as Link Pass-Through, Interlink Fault Feedback, and Loopback allow network administrators to “see everything” for more efficient troubleshooting and less on-site maintenance. These cost and time saving features, along with a lifetime warranty and free worldwide technical support, make Perle Ethernet Repeaters the smart choice for IT professionals.
eR-S1110 Ethernet Repeater Features
Extend Ethernet over twisted pair
Extend an Ethernet link over category 5e, 6 and 7 cabling up to an additional 100m / 328ft
The eR-S1110 can automatically detect Ethernet port speed and do a rate conversion between the two ports if the Ethernet speed is different.
Plug and Play operation
Perle Ethernet Repeaters will automatically configure your Ethernet connection. Once a connection is made, both ends will automatically adjust relevant Ethernet parameters to establish connection.
Ethernet Link Pass-Through
With Link Pass-Through the state of the 10/100/1000Base-T Ethernet connection is “passed through” the Ethernet link to the 10/100/1000Base-T Ethernet connection on its remote peer. A managed switch on the remote end can then report the state (link up or link down) to its network management system so that any errors can be detected and recovered early.
Competitive Ethernet repeaters without this feature will never detect or report any error conditions.
The Ethernet Repeater supports auto negotiation on the 10/100/1000Base-T interface.
Auto-MDIX(Automatic Medium-Dependent Interface crossover) detects the signaling on the 10/100/1000 Ethernet RJ45 interface and determines the type of cable connected (straight-through or crossover) and automatically adopts a compatible pinout.
Jumbo Packets: Transparent to Jumbo Frames with a maximum MTU size of 10,024 bytes
VLAN: Transparent to tagged VLAN ( 802.1Q ) packets.
Transparent to IP Video compression protocols
Fully transparent to such IP video compression schemes such as MPEG-4, H.264 and MJPEG.
Power Strain Relief strap. A strain relief strap is provided to ensure a solid and secure power connection to the Ethernet Repeater. Ideal for areas that may be exposed to vibration.
eR-S1110 – Gigabit Ethernet Repeater and Rate Converter – 2 x 10/100/1000Base-T (RJ45) ports. Auto-sensing and rate converting. Extend existing Ethernet cable length by 100m (300ft). 802.3af Power over Ethernet (PoE) compliant PD. Power supply included.